Engineered and
Built to Order

Comanche Waste Heat

Waste Heat Recovery

Request a Quote

Let our Problem Solvers quote a boiler designed for your needs. Request a Quote

Give us a call at (620) 662-6693 or EMAIL US

Capacity: Customized for job specific conditions, with experience in designing units over 40,000 lb/hr.

Fuel Capabilities: Customized for application

Pass: 2-pass All Tubes

Tube Type: Smooth Tubes or Rifled Tubes

Steam Design Pressure: 150 - 300 psig

Hot Water Design Pressure: Section I vessels 150 - 250 psig

Resources

General Description

Superior’s Comanche Two Pass Heat Recovery units are designed with 2 “ & 2.5” heat transfer tubes.

Features

  • Customized design engineered for your specific solution.
  • Available with dual chamber design or supplemental firing
  • 1,800°F maximum inlet temperature
  • Roller-bearing supported single-hinged rear door for total fireside access (except wetback)
  • Typical applications: moderate particulate levels, space limitation, high steam pressures, inlet temperatures to 1800° F.

Construction

  • 12 gauge tubes
  • 3/4″ tube sheets with 3/4″ ligament spacing
  • 2", 2.5", or 3" tubes
  • Furnaces thicker than ASME code requirements
  • Corrugated to help reduce the stresses associated with expansion and contraction

Quality

All Waste Heat Recovery Boilers are made with 12 gauge tubes, 3/4” tube sheets with 3/4” ligament spacing and furnaces thicker than ASME code requirements. All section I furnaces above 24” diameter are corrugated to help reduce the stresses associated with expansion and contraction.

Safety

Superior’s Waste Heat Recovery Boilers are trimmed and equipped with safeguards and code piping. Each boiler is inspected by independent code inspectors. Factory mounted and wired packaged burners are available from all burner manufacturers for supplemental firing.

Our Problem Solvers Explain

This site is registered on Toolset.com as a development site.